4 x Alaska Refrigerants 3in1 R134a Replacement Refrigerant with PAG 100 Oil and Sealer

Description

Package contents:

4 cans of 3in1 HC134a hydrocarbon refrigerant replacement gas. The package equals 4 × 500 g of R134a refrigerant and contains 4 × 185 g of gas.
(NOTE: Charging hose not included in the package!)

Note: Do not use this product with R12 systems unless you are certain the system does not contain mineral oil.
No F-gas certification is required to order this replacement gas. A 1/acme-thread compatible hose is required for proper use.

Bring your vehicle’s air conditioning system back to life — this innovative 3-in-1 solution combines the power of a high-performance hydrocarbon gas with high-quality PAG oil and a reliable sealant to revitalize and maintain your A/C system.

Order now and refill your car, van, motorhome, SUV, truck, or even agricultural vehicle’s refrigerant in just a few minutes. This refrigerant is compatible exclusively with R134a air conditioning systems.
Please note: The product can only be used with the appropriate charging hose and must be connected only to the low-pressure service port of the A/C system.

Our product is compatible with all vehicles manufactured between 1994 and 2016 that use R134a refrigerant.
• Contains natural, non-toxic, hydrocarbon-based gases that do not contribute to the greenhouse effect.
• Safe home-use refill kit – recharge your vehicle’s A/C system in less than 10 minutes.
• Avoid high service costs by using our product.
• Our refrigerant delivers 2.7 times greater performance than traditional R134a, improving both fuel economy and cooling efficiency.
• One can of 3in1 HC134a Alaska Refrigerants equals 500 g of R134a refrigerant.
• Compatible with the following vehicle types: passenger cars, vans, motorhomes, SUVs, trucks, and agricultural vehicles.

HOW TO USE THE PRODUCT:
• Start the engine and set the A/C to the coldest setting. Set the fan to maximum or automatic mode.
• Locate your vehicle’s low-pressure service port. Pull back the plastic ring, connect the hose to the port, then release the ring. You should hear a click upon connection.
• Turn the can upside down and slowly open the valve to allow the contents to enter the A/C system.
IMPORTANT! Continuously monitor the pressure gauge and stop the process once the correct pressure is reached.
• When the can is empty or the desired pressure is achieved, close the valve to seal the can. Turn off the engine and disconnect the hose.
• Restart the vehicle and check the cooling performance of the A/C system. Wait 10 minutes and measure the pressure again.